Specifications

GURANTEED TECHNICAL PARTICULARS - ANNEXURE-VII
Overload, Fault, Battery Voltage Low/Discharged
3.2 BATTERIES for S no 3.1 with 60 minutes backup
Type
Sealed Maintenance free.
Make Panasonic/CSB/Yuasa/Exide
Back-up time
At least 60 minutes on full load
Operating Temperature
Range
0-45 degree centigrade.
Rack Rack for Batteries to be included (As per Purchaser/Space
Requirement)
4 NETWORKING COMPONENTS (ACTIVE)
4.1
ROUTER with the following Specifications For Chandigarh
Architecture:
Should have support for Data, Voice, Video, Security and mobility services
Should be chassis based & modular architecture with multicore processor for scalability and should
be a single box configuration for ease of management.
Should have integrated redundant power supply.
Should have embedded hardware based (IPSec and SSL) Encryption card accelerator
Should support complete Firewall, IPS features.
Should have 1Gb RAM should be upgradeable to 2Gb
Should have 256Mb flash and should be upgradeable to 4Gb
Should have four free slots for future expansion.
Should have integrated USB port to provide console, storage and secure token capabilities
Chassis should be 19” rack mountable type.
Should be supplied with necessary power cards, data cables, connectors, CD’s, manuals, bracket
accessories, wire managers and other appropriate accessories.
Performance:
Shall support high performance traffic forwarding upto 150Mbps with con-current services
Shall support variety of interfaces like V.35 Sync Serial (64Kbps, 2 Mbps), G.703, Ch-E1, 3G, E3
Interfaces for future uplink purposes, Ethernet Interfaces – 1Gbps, 10/100 Mbps, 802.3af, ISDN PRI,
BRI, ATM, Digital/Analog dialup and remote access modules,
Shall support voice interface like FXS, FXO, E&M, T1/E1
Shall support DSL connectivity using ADSL, G.SHDSL
Should support integrated capability to host multiple application min. four like Unified
Communication, Video Surveillance, Storage System, Network services, or customer application, etc
using different processor, storage, memory to optimize and consolid
Should support other IP Services like GRE tunneling, ACLs, IPSEC VPNs, Firewalling, NAT
services.
Shall support Voice traffic optimization with features like WRED, H-QoS, RSVP, performance routing
and network based application routing
Should support four onboard voice and video capable digital signal processor
Should support per port PoE power monitoring
Should support management of power to module slots, to reduce energy consumption
High Availability
Shall support redundant Gigabit Ethernet connection to LAN
Shall have Redundant Power supply
Shall support fast reboot for minimum network downtime
Shall support Non-Stop forwarding for fast re-convergence of routing protocols
Shall support boot options like booting from TFTP server, Network node and Flash Memory
Shall support multiple storage of multiple images and configurations
Shall support link aggregation using LACP as per IEEE 802.3ad
Shall support VRRP or equivalent
Protocol Support
Should support Routing protocols like IS-IS, RIP v1 & RIP v2, OSPF ver2, OSPF on demand, BGP4,
BGP Route-Reflector
Should support Multicast routing protocols IGMPv3, PIM-SM, PIM-SS, DVMRP, IPv4 to IPv6
Multicast, BFD, IEEE802.1ah, IEEE802.3ag
Should support DHCPv6, IPv6 QoS, RIPng, OSPFv3
Shall support MPLS, Layer2 and Layer3 VPN, L2TPv3
Support for Load balancing Protocol.
Support unequal cost link load sharing to better utilize the alternate paths
Configuration Roll Back to recover the mis-configured router to last good configuration
Encapsulation Support
Should support Encapsulation like Ethernet, 802.1q, PPP, MLPPP, FR, MLFR, HDLC, Serial (RS232,
RS449, X.21, V.35, EIA530), PPPoE and ATM
Security Features:
Support Standard ACL, Extended ACL, ACL that can match arbitrary bits of packet bits of a packet at
an arbitrary depth in the packet header and payload
7