Product Manual
Table Of Contents
- ACCESSORIES
- 3. If using the motorized illuminated floor brush without the extension tube, simply attach it to the main body. It will "click" when secure.
- *Repeat Steps 1-3 if using motorized upholstery nozzle*
- 1. Attach the extension tube to the main body by slotting it into place.
- 2. Attach the accessory to the base of the extension tube via the connector. It will "click" into place.
- 3. If using accessories without the extension tube, simply attach them to the main body. It will "click" when secure.
- BEFORE FIRST USE
- NOTE: In the event of a maintenance issue with the product such as a jammed brush roller, all three BLUE indicator lights will flash on around 10 seconds then off until the issue is resolved, in this case turn the cleaner off until the issue is rectif...
- Battery Charging
- 1. Push the release button and take the battery module out.
- 2. You can also charge the battery while it is inside the vacuum. The three blue indicator lights will indicate one by one to show the battery being charged. When the battery is fully charged, all three lights will stay blue.
- OPERATING THE VACUUM
- MAINTAINING THE VACUUM
- Cleaning the dust container
- 3. Lift to remove the microfiber filter.
- 4. Rinse the filters thoroughly under cold water. Do not use soap or other cleaning solvents.
- Cleaning the brush roller:
- DISPOSAL
Cleaning the brush roller:
1. Remove the brush roller from the brush housing. Slide the brush roller fastener
(A) away from the brush as below.
2. Carefully clean and remove the hair and debris from the brush roller. Wipe to
clean only, do not use any soap or harsh cleaning solvents.
3. If brush roller is damp, allow to dry completely before replacing.
4. Slide fastener (A) to original position to secure the brush roller.