Product Manual
Table Of Contents
- ACCESSORIES
- 3. If using the motorized illuminated floor brush without the extension tube, simply attach it to the main body. It will "click" when secure.
- *Repeat Steps 1-3 if using motorized upholstery nozzle*
- 1. Attach the extension tube to the main body by slotting it into place.
- 2. Attach the accessory to the base of the extension tube via the connector. It will "click" into place.
- 3. If using accessories without the extension tube, simply attach them to the main body. It will "click" when secure.
- BEFORE FIRST USE
- NOTE: In the event of a maintenance issue with the product such as a jammed brush roller, all three BLUE indicator lights will flash on around 10 seconds then off until the issue is resolved, in this case turn the cleaner off until the issue is rectif...
- Battery Charging
- 1. Push the release button and take the battery module out.
- 2. You can also charge the battery while it is inside the vacuum. The three blue indicator lights will indicate one by one to show the battery being charged. When the battery is fully charged, all three lights will stay blue.
- OPERATING THE VACUUM
- MAINTAINING THE VACUUM
- Cleaning the dust container
- 3. Lift to remove the microfiber filter.
- 4. Rinse the filters thoroughly under cold water. Do not use soap or other cleaning solvents.
- Cleaning the brush roller:
- DISPOSAL
ACCESSORIES
Extension Tube: Use for extended reach when using as an upright unit or
for hard to reach places.
Motorized Illuminated Floor Brush: Use this for hard floors and tight knit
rugs and carpets. Easily picks up dirt dust and small debris.
Motorized Upholstery Nozzle: Use this for upholstery, stairs, vehicles etc.
Combo Tool: Use this for vacuuming fabric furnishings such as sofas
armchairs and curtains.
Crevice Nozzle: Features a narrow nozzle that makes for quick, easy
cleanup of tight spaces such as corners and hard to reach areas.
ASSEMBLY INSTRUCTIONS
NOTE: Before assembling the vacuum, install the included wall mount
hook to the wall. Ensure the wall mount is placed high enough for the
vacuum to be securely mounted.
Assembling the main body:
1.
Install the battery into the housing by sliding it into the appropriate
slot. It will "click" into place.