Owner's Manual

12
OPERATION
When using the charger, basic precautions should always be followed,
including the following:
Battery MUST be REMOVED from the Vacuum
prior to charging. Failure to follow the warnings and
instructions may result in shock, fire, property
damage and or serious injury or death.
CHARGING LITHIUM POLYMER BATTERY PACKS
It is not necessary to drain the battery pack completely before
recharging. If the charger’s light is not lit at any point during the
charging process, remove the battery pack from the charger to avoid
damaging the product. DO NOT insert another battery. Contact Atrix
with any issues.
BATTERY PROTECTION FEATURE
The 26-volt Lithium Polymer batteries are designed with features that
protect the Lithium Polymer cells and maximize battery life. There is a
built-in BMS (Battery Management System) which controls the
charging process and provides safety to the system. When the battery
has reached its minimum voltage level the electronics will shut off the
battery. Once the battery shuts off, it must be recharged. Batteries
arrive with little or no power reserve. Please charge before using.
PREPARING BATTERY PACK FOR CHARGING
BATTERY MUST BE REMOVED FROM VACUUM PRIOR TO CHARGING
AND DURING CHARGING PROCESS.
1. Turn off the power switch.
2. Place vacuum on the floor and rest on its back (harness).
3. Unlock the battery pack by turning knob counterclockwise to the
unlock position.
4. Place one hand on the vacuum just above battery, and place
other hand under the battery with four fingers in the battery
slot and thumb on top of battery.
5. Pull up on battery to remove.