JET RED BACKPACK VACUUM OWNER’S MANUAL Model: JR8BPV 120V 12A, 1400W ETL US Canada Atrix 1350 Larc Industrial Blvd. Burnsville, MN 55337 www.atrix.com sales@atrix.com Telephone: 952.894.6154 Toll Free Telephone: 800.222.6154 Fax: 952.894.
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING APPLIANCE WARNING: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR INJURY: 1. Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing. 2. Electrical shock may occur if used outdoors or on wet surfaces. 3. Do not allow to be used as a toy. Close attention is necessary when used by or near children. 4.
11. Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes. 12. Do not use without filter in place. 13. Turn off all controls before unplugging. 14. Use extra care when cleaning on stairs. 15. Do not use to pick up any liquids, including flammable or combustible liquids such as gasoline or use in areas where they may be present. 16. Connect to a properly grounded outlet only. 17.
GET TO KNOW YOUR ERGO BACKPACK VACUUM 1. Furniture Nozzle (BP40) 2. Air Driven Turbo Brush (BP44) 3. Mini Turbo Brush (JRMTB) 4. Floor Tool (BP43-1) 5. 3-in-1 Multi-Surface Tool (JR31) 6. Extension Wand, 22”-37” (BP39) 7. Hose (JRBPH) 8. Filter Bags (VACBPFB) 9. Shakeout Bag (VACBP8) 10. & 11. Premotor and Exhaust Filter Set (BPFILPACK) 12. Exhaust Filter Cover (BP18) 13. Jet Red Lid (JRAILID) Hose Inlet 14. Carry Handle 15. Harness Back Support 16. Cord Strain Relief (BP99) 17.
OPERATING INSTRUCTIONS Warning: To reduce the risk of electric shock, the power cord must be disconnected before removing the dust bag, shake-out bag, changing the filters or performing maintenance or trouble-shooting checks. Important: Do NOT use the vacuum without all filters, shake-out bag, and HEPA dust bag in place. Attaching the Flexible Hose to the Vacuum The flexible hose should be connected to the vacuum before strapping the unit to your back. 1. Push/press fit the hose into the lid opening.
2. To extend the length, push forward on the plastic button and pull the inner tube outward to extend for a longer reach. Manual Suction Control Your vacuum cleaner includes a manual variable suction control on the flexible hose handle. The suction power can be adjusted by moving the suction regulator to the desired position between open and closed. Open gives you less suction, closed maximum suction.
2. Step on the floor to carpet selector to adjust the height of the brushes. There are two different heights. The tool allows you to retract the bristle brushes when being used on the carpet or rugs, and extend when being used on wood or tile surfaces. 3. To remove the telescopic tube from the floor to carpet brush, pull the telescopic tube out from the floor to carpet brush. Air Driven Turbo Brush The efficiency of your air driven turbo brush depends on the bristle brush rotating at high speed.
4. To attach the air driven turbo brush, insert the telescopic tube into the air driven turbo brush. 5. To adjust the suction control on the air driven turbo brush, slide the suction control for more or less as desired. Using Your Vacuum 1. Insert the power plug into the extension cord, then plug the extension cord into the wall outlet. 2. Make a loop with the extension cord and put the loop through the extension cord relief. Put the extension cord around the hook and pull the cord tight. (See page 11) 3.
2. Pull the tab on the HEPA bag holder out slightly and flip upwards. (Fig. 2) 3. Holding the HEPA bag in your hand, slide/pull it out of the bag holder and dispose. 4. Insert/slide new bag. Cardboard face should rest securely in the bag cover guides. (Fig. 3) Fig. 3 Fig. 4 Cleaning & Replacing the Shake-Out Bag 1. Remove the Shake-out bag from the canister. Hold the handle on the bottom of the bag, shaking vigorously over a garbage receptacle and preferably outdoors. (Fig. 4) 2.
1. Remove the shake-out bag from the canister. The HEPA pre-motor filter is located underneath the shake-out bag. To remove the HEPA pre-motor filter, place your index finger underneath the edge of the premotor filter, and using your thumb press the tab toward the center of the filter to release, then lift the side of the HEPA pre-motor filter and pull upwards on filter. 2.
2. Remove the exhaust filter. 3. As necessary, hand wash or replace the cloth filter with tap water and let dry before reinserting it. (Fig.
Atrix JET RED Backpack Vacuum WARRANTY INFORMATION Warranty/Service Information: For warranty service information, please contact Atrix or your local Atrix distributor. Atrix Jet Red Backpack Vacuum Limited Warranty: To the original user purchasing the Atrix Jet Red Backpack Vacuum, Atrix warrants that the vacuum will be free of defects in material and manufacture for a period of one (1) year from the date of purchase.
