User Manual

9
Cleaning the Shake-Out Bag:
1 Remove the shake-out bag,
shake vigorously outdoors or
over your trash bin until there
is no more dust.
2 The shake-out bag is hand
washable in lukewarm water.
3 Allow to air dry for 24 hours .
The shake-out bag should be
replaced when needed. Never
replace into the vacuum if
still wet
4 Replace clean shake-out bag
in unit, and replace the
canister lid onto the vacuum.
Cleaning the HEPA Pre-Motor
Filter
Important – Please Note:
The HEPA pre-motor filter will
stop most of the tiniest dust
particles and airborne allergens
from re-entering the air you
breathe. In fact, it stops 99.97%
of all particles as small as 0.3
microns – many times smaller
than a human hair! Because of
this incredible filtration
performance, the HEPA pre-
motor filter will accumulate many
fine dust particles that are
difficult to see. Be assured that
the HEPA pre-motor filter is
doing the job. Clean or replace
the HEPA pre-motor filter from
time to time, when it is visibly
dirty or if you notice reduced
suction, as described in this
section.
1 Remove the shake-out bag from
the canister. The HEPA pre-
motor filter is located underneath
the shake-out bag. Pull up near
the tabs on the sides of the HEPA
filter. This is a press fit system.
2 Vigorously “Tap Clean” the HEPA
pre-motor filter on a hard surface
to remove any residual dust that
might still be on the HEPA pre-
motor filter.
3 You can wash the HEPA pre-
motor filter by running it under
the tap and allowing the water to
run on the dirty side at least once
a month or when suction appears
to be decreased.
Warning: To reduce the risk of electric shock, the power cord must be
disconnected before removing the dust bag, shake-out bag, changing
the filters or performing maintenance or trouble-shooting checks.