Installation & Assembly

Step-d
● Mounting the Track
Sit the wall spacer base onto the wall.
See picture in step-d
IMPORTANT
1. Align the holes on the track with
the drilled holes on the wall.
2.Place one Lag Screw through the
hole on one end hole of the Track,
through a Spacer, and drive the Lag
Screw into the pilot hole. DO NOT fully
fasten Lag Screw. Repeat process for
Lag Screw on opposite end of Track.
DO NOT fully fasten Lag Screw.
3.For remaining holes in Track, insert
Lag Screw through hole and through
Spacer, and drive into pilot hole.
DO NOT fully tighten Lag Screws.
4.After all Lag Screws and Spacers are
in place,use a level on top of the Track
to make sure it is properly leveled.While
the level is on top of the Track, fasten all
Lag Screws.
S
t
ep-e
(MM-20D for example)
5-3/16"
132mm
● Installing Hangers
1.Mark the holes for the Door Hangers on
the side of the door facing away from the
Track as shown in the picture.
Drill the holes using a 10mm bit.
2.Insert the Bolts through the door from
wall side,and secure the Door Hanger by
the two Washers and an Acorn Nut to each
Bolt. Hand tighten both Nuts before securing
with a wrench.
3.Repeat Step-e-1 and Step-e-2 on the
other side of the door edge.
S
t
ep-
f
● Install Anti-Jump Pads
1.Loosely screw the anti-jump pad onto the
top of the door near the hanger.
2.Spin and turn it far away from the wall.
1-9/16"
40mm
3-35/64"
90mm
3-15/16"
100mm
6