Instruction manual

23
Selection Submenu
Svítí
Information
Scale of O2
End of the test
(+,-)
After pressing the „+“ button, „calibrate“ appears
on dipslay. Calibration takes apporximately 600
seconds. Automatic calibration is done only, when
there was no fire in the boiler for 48 hours and
operation time of the sesor is longer than 200
hours. sa na displeji objaví „kalibrovať“
During manual setting of the scale there can be no
fire in the boiler, nor smoulder of fuel residuals! If
it is not necessary to adjust the scale, press „←“
for the next step.
Tip: Early exit from menu is possible by pressing
of „+“ and „-“.
Flue gas fan
End of the test (+,-)
By pressing + switch on the flue gas fan
By pressing – switch off the flue gas fan
By pressing ← select next point of the test
Circulating pump
End of the test (+,-)
By pressing + switch on circuiting pump
By pressing – switch off circuiting pump
By pressing ← select next point of the test
Primary motor
End of the test (+,-)
By pressing + open primary air flap
By pressing – close primary air flap
By pressing ← select next point of the test
Secondary motor
End of the test (+,-)
By pressing + open secondary air flap
By pressing – close secondary air flap
By pressing ← select next point of the test
Illumination
End of the test (+,-)
By pressing + switch on illumination of text display
By pressing – switch off illumination of text display
By pressing ← select next point of the test
Control light 1
End of the test (+,-)
By pressing + switch on control light1
By pressing – switch off kontrolku 1
By pressing ← select next point of the test
Control light 2
End of the test (+,-)
By pressing + switch on control light 2
By pressing – switch off control light 2
By pressing ← select next point of the test
Test of device
Control light 3
End of the test (+,-)
By pressing + switch on control light 3
By pressing – switch off control light 3
By pressing ← select next point of the test
Safety test
Setting
FINISH
Safety test
If the boiler is switched on, it is possible to select the safety test. However, it is necessary to let the
boiler work for 1 hour at least, to achieve output appropriate to the normal operation state.
Test is selected and performed by the ← button (enter into menu „Selection“ ), then by the button -
select from menu „Safety test“ and confirm selection by the
← button. Safety test starts