Technical information

d1=d2-200 mm
ATTACK AK ATTACK AS
ATTACK AS
Description of device
Tank for accumulation of heating water with single heating coil (e.g. solar system), accessorized with welded flange to fit the tubular
exchanger of appropriate size, following concrete application and required output.
Type
Type line of tanks with volume of 500, 800, 1000 litres, also with possibility to install electrical heating device.
Thermal isolation
The accumulation tanks are delivered with detachable isolation of 100mm width, soft polyurethane with leatherette covering.
Specification
Max. operation pressure in the accumulation tank: 6 bar, max. operation temperature in the tank: 95 °C
The accumulation tanks are
delivered with
Technical data
Description:
Accumulation tank is permanently connected to the closed heating system. "ATTACK AS"
3
welded flanges for exchangers with threads of G1“ or G / “. If the welded part on the exchanger is not used, the
4
6
blinding flange has to be used. Tanks can be accessorized with electrical heating devices with thread of G / “ up to the output of
4
12 kW (suitable output of device is adequate to its length and diameter of tank).
Specification
Max. operation pressure of the accumulation tank: 6 bar
Max. operation temperature of the accumulation tank: 95 °C
Technical data
Description:
Accumulation tank „ATTACK AK“ is permanently connected to the closed heating system. Internal walls are not enameled. Tanks
6
can be accessorized with electrical heating devices with thread of G / “ up to the output of 12 kW (suitable output of device is
4
adequate to its length and diameter of tank). Fitting of individual outlets of tank is made according to the connected circuits.
ATTACK AK 500 with isolation
ATTACK AK 800 with isolation
ATTACK AK 1000 with isolation
ATTACK AS 500 with isolation
ATTACK AS 800 with isolation
tanks "d2" = 800 mm x height1970 mm
990 mm x 1750 mmtanks "d2" = height
990 mm x 2050 mmtanks "d2" = height
800 mm x 1970 mmtanks "d2" = height
990 mm x 1750 mmtanks "d2" = height
ATTACK AS 1000 with isolation
990 mm x 2050 mmtanks "d2" = height
®
EQUITHERMICAL CONTROLLER ATTACK REGU-MAX
®
ACCESSORIES TO THE ATTACK BOILERS
Equithermical controller ATTACK REGU-MAX
is the top regulation element for all modifications of
wood gasifying boilers ATTACK DPX and DP.
Controller ATTACK is intended for regulation of
heating systems, including regulation of heating
water. It is used for regulation of low-temperature
and warm-water systems. it is possible to connect
the regulator with two types of room units ( with
and without display).
Advantages of installation with accumulation tanks:
* equalisation of inequal boiler output and higher comfort
* lower fuel consume – boiler works at full output, i.e. with optimum efficiency
* long lifetime of boiler and chimney – minimum production of tars and acids at full ouput
* possibility to combine with another means of heating (accumulation electricity, solar devices)
* possibility to combine radiators with underfloor heating
* higher comfort of attendance