User Manual

2.3 Auto setup
ADS1000 Series Digital Storage Oscilloscopes have auto setup function, which
can identify the type of waveform and adjust controls to produce a usable display of
the input signal.
“AUTO” is the auto Set up button.
Table 2-1 Auto set function Menu:
Option Introduction

˄Multi-cycle sine˅
Auto set the screen and display several
cyc signal.

˄Single-cycle sine˅
Set the screen and auto display single
cyc signal.

˄Rising edge˅
Auto set and show the rising time.

˄Falling edge˅
Auto set and show the falling time.

˄Undo Setup˅
Causes the oscilloscope to recall the
previous setup.
Auto set determines the trigger source based on the following conditions:
Ɣ If multiple channels have signals, channel with the lowest frequency signal.
Ɣ No signals found, the lowest-numbered channel displayed when Auto set was
invoked
Ɣ No signals found and no channels displayed, oscilloscope displays and uses
channel 1.
Input a signal to Channel 1, press the “Auto” button (See picture 2-3):
14