User Manual

2.6 Vertical System
Showing as follow picture, the buttons and knobs are useful in the vertical system

Volt/div knob
Vertical POSITION
knob
Picture 2-5
The vertical control, which each channel has, could be used for displaying waveform,
rectify scale and position.
2.6.1 CH1 & CH2 Channel
Table 2-3 CH1 & CH2 function menu 1:
Option Setting Introduction
Coupling DC
AC
GND
DC passes both AC and DC components of the
input signal.
AC blocks the DC component of the input signal
and attenuates signals below 10 Hz.
GND disconnects the input signal.
BW limit On
Off
Limits the bandwidth to reduce display noise; filters
the signal to reduce noise and other unwanted high
frequency components.
Volts/Div Coarse
Fine
Selects the resolution of the Volts/Div knob
Coarse defines a 1-2-5 sequence.
Fine changes the resolution to small steps between
the coarse settings.
Probe 1X
10X
100X
1000X
Set to match the type of probe you are using to
ensure correct vertical readouts.
Next Page Page 1/2 Press this button to enter second page menu.
18