User Manual

Table 2-4 CH1 & CH2 function menu 2:
Option Setting Instruction
Invert on
off
Turn on invert function.
Turn off invert function.
Input
0¡
¡
Setup 0¡DVinput impedance 
Setup ¡DVinput impedance 
$'6&($'6&(FRQWDLQWKLVRSWLRQ
Digital Filter Press this button to enter the “Digital Filter
menu”.(See table 2-5)
Next Page Page 2/2 Press this button to return the first page menu.
Table 2-5 Digital Filter function menu:
Option Setting Introduction
Digital Filter On
Off
Turn on the digital filter.
Turn off the digital filter.
Type Setup as LPF(Low Pass Filter).
Setup as HPF(High Pass Filter).
Setup as BPF(Band Pass Filter).
Setup as BRF(Band Reject Filter).
Upper_limit Turn the “Universal” knob to set upper limit.
Lower_limit Turn the “Universal” knob to set lower limit.
Return Return the digital filter main menu.
Ŷ “GND” Coupling: Use GND coupling to display a zero-volt waveform. Internally,
the channel input is connected to a zero-volt reference level.
Ŷ Fine Resolution˖The vertical scale readout displays the actual Volts/Div setting
while in the fine resolution setting. Changing the setting to coarse does not change
the vertical scale until the VOLTS/DIV control is adjusted.
Ŷ Wave Cancel˖Press the menu button for the channel to display its vertical menu.
Push the menu button again to remove the waveform.
19