User Manual

Set to DC
cou
p
lin
g
Picture 2-7
DC Status
Ɣ Press“CH1”ĺ“Coupling”ĺ“GND”, Set to GROUND mode. It disconnects the
input signal.
Set to GND
cou
p
lin
g
Picture 2-8
2. Set up the channel bandwidth limit
GND Status
Take the CH1 for example; the tested signal is a pulse signal with the high
frequency surge:
Ɣ Press “CH1”ĺ“BW Limit”ĺ “On”ˈSet the band width Limited to open state. The
high frequency component which is higher than 20MHz obstructed.
12