User Manual

Next Page Page 1/2 Enter the second page of Alternative trigger menu.

Table 2-26 Set trigger mode to slope trigger function menu 1

Option Setting Instruction

Type Alternative The trigger signal comes from two vertical channels

when you use alternative trigger. In this mode, you can

observe two irrelative signals at the same time.

Source

CH1

CH2

Set trigger type information for CH1 signal

Set trigger type information for CH2 signal

Mode Slope

Set trigger type of the vertical channel signal to slope

trigger.

When



Select slope trigger condition.

Next Page Page 1/2 Enter the second page of the alternative trigger.

Table 2-27 Set trigger mode to slope trigger function menu 2

Option Setting Instruction

Time

ǇSet timeǈ

Turn the “Universal” knob to set the slope

time. Time setup range is 20ns-10s.

Vertical



Select the trigger level that can be adjusted by

“LEVEL” knob. You can adjust “LEVEL A”,

“LEVEL B” or adjust them at the same time.

Set up



Enter the “Trigger setup menu”(see table

2-14).

3DJH

Return the first page of “Alternative trigger

menu”.

Operate Instruction:

Observe two irrelative channel signals, follow these steps˖

1. Input two irrelative signals to channel 1 and channel 2.

2. Press the AUTO button.

3. Press the TRIG MENU button to enter “trigger menu”.

4. Press the “Type” option button to select “Alternative”.

5. Press the “Source” option button to select “CH1”.

6. Press the “S/div” knob to optimize waveform display.