User Manual

Manual Mode

Table 2-32 Manual cursor function menu:

Option Setting Instruction

Cursor Mode Manual In this menu, set the manual cursor measure.

Type Voltage

Time

Use cursor to measure voltage parameters.

Use cursor to measure time parameters.

Source CH1

CH2

MATH

REFA

REFB

Select input signal channel.

Cur A

Select this optionˈturn the “Universal” knob to

adjust cursor A.

Cur B

Select this optionˈturn the “Universal” knob to

adjust cursor B.

In this mode, the screen displays two horizontal parallel cursors or vertical

parallel cursors to measure voltage or time. You can move the cursor by turning the

“Universal” knob. Before using cursors, you should make sure that you have set the

signal source as the channel for measuring.

Ŷ Voltage Cursor: Voltage cursors appear as horizontal lines on the display and

measure the vertical parameters.

Ŷ Time Cursor: Time cursors appear as vertical lines on the display and measure the

horizontal parameters.

Ŷ Cursor Moving: Use the “universal” knob to move cursor1 and cursor2 .They

could be moved when the corresponding cursor option are selected, and cursor value

will display on the bottom left and top left of the screen when you move the cursor.

To do manual cursor measurements, follow these steps:

1. Press CURSOR button to enter the cursor function menu.

2. Press the “Cursor Mode” option button to select “Manual”.

3. Press the “Type” option button to select “Voltage” or “Time”.

4. Press the “Source” option button to select “CH1”, “CH2”, “MATH”, “REFA” or

“REFB” according to input signal channel.

5. Select “Cur A”, turn the “Universal” knob to adjust Cursor A.

6. Select “Cur B”, turn the “Universal” knob to adjust cursor B.