User Manual

In this mode, the screen displays two cross cursors. The cross cursor sets the
position on the waveform automatically. You could adjust cursor’s horizontal position
on the waveform by turning the “Universal” knob. The oscilloscope displays the
values on the top of the right screen.
To do track cursor measurement, follow these steps:
1. Press CURSOR button to enter the cursor measure function menu.
2. Press the “Cursor Mode” option button to select “Track”.
3. Press the “Cursor A” option button to select the input signal channel.
4. Press the “Cursor B” option button to select the input signal channel.
5. Select “Cur A”, turn the “Universal” knob to move Cursor A horizontally.
6. Select “Cur B”, turn the “Universal” knob to move Cursor B horizontally.
7. The measurement values are displayed on the left of the top corner:
AėT: The horizontal position of Cursor A (Time cursor centered around the
midpoint of screen).
AėV: The Vertical position of Cursor A (Voltage cursor centered around
channel ground level).
BėT: The horizontal position of Cursor B (Time cursor centered around the
midpoint of screen).
BėV: The Vertical position of Cursor B (Voltage cursor centered around
channel ground level).
ƸT: Horizontal space between Cursor A and Cursor B (Time value between two
cursors).
1/ƸT: The reciprocal of horizontal space between cursor A and cursor B.
ƸV: Vertical space between Cursor A and Cursor B (Voltage value between two
cursors).
69