User Manual

Save setup to USB flash drive, follow these steps˖
For example: Save setup that the oscilloscope displays waveform as the form
of “Dots” to the oscilloscope’s internal memorizer.
1˅ Press the “SAVE/RECALL” button to select “Setups”.
2˅ Insert USB flash drive to USB host port of the oscilloscope and wait that the
oscilloscope has initialized USB flash drive (about ten seconds).
3˅ Press the “Save to” option button to select “file”.
4˅ Press the “Save” option button then you’ll go into the Save/Recall interface.
5˅ Press the “New folder” button to creat a new folder
6˅ Press the “Del folder” option button to delete a folder
7˅ Press the “Modify” option button to modify a folder.
8˅ Press the “New file” option button to creat a new file
9˅ Press the “Del file” option button to delete a file
10) Press “the next page ” option button and press the “Rename” option button to
modify the name of the file or the folder.
11) Press the “Confirm”option button and you save the set to the USB drive.
Recall setup data from USB flash drive, follow these steps:
1˅ Press the “SAVE/RECALL” button.
2˅ Press the “Type” button to select “Setups”.
3˅ Insert USB flash drive to USB host port of the oscilloscope and wait that the
oscilloscope has initialized USB flash drive (about ten seconds).
4˅ Press the “Save to” option button to select “File”.
5˅ Press the “Save” option button then you’ll go into the Save/Recall interface .
6˅ Choose the file you want then press the “Load” option button (about five seconds,
there is a prompting message that “Read data success”), now setup data have been
recalled from USB flash drive.
Ŷ RECALL FACTORY
You can use this option to recall the factory setup.
81