User Manual

ManualsBrandsATTEN ManualsSoldering EquipmentSMD Rework Station ATTEN AT8502D (110 V)

MFR Add: Building A29, Tanglang Industrial Zone, Xili,

Nanshan, Shenzhen, 518055, P. R. China

User's Manual

SOLDERING STATION

SMD REWOEK

AT8502D

Intelligent lead-free rework station

CBN 019006

ATTEN INSTRUMENTS

Digital Storage Oscilloscope

RF Microwave Instruments RF Microwave Components

Spectrum Analyzers Regulated DC Power Supply

Regulated AC Power Supply Switching DC Power Supply

Signal Generator Attenuator Amplifier

850 Rework Station 936 Constant Temp Soldering Station

Electronic Instruments Electronic Tools

FRANCHISER

2 in 1

THERMO-CONTROL ANTI-STATIC

Summary of content (9 pages)

PAGE 1
ATTEN INSTRUMENTS RF Microwave Instruments RF Microwave Components Spectrum Analyzers Regulated DC Power Supply Regulated AC Power Supply Switching DC Power Supply Digital Storage Oscilloscope Signal Generator Attenuator 850 Rework Station 936 Constant Temp Soldering Station Electronic Instruments Electronic Tools Amplifier AT8502D SOLDERING STATION SMD REWOEK 2 in 1 FRANCHISER THERMO-CONTROL ANTI-STATIC Intelligent lead-free rework station User's Manual MFR Add: Building A29, Tanglang Industrial Zone
PAGE 2
PAGE 3
PAGE 4
Installation: Power: The brackets for the handles must be installed when operating for the first time. Please see the following illustration: 1. Please fix the bracket by tightening the four screws according to the illustration and your personal habit. 2. According to your selection, dismantle the two screws on the left or the right, which fix the bracket of the handle. 3.
PAGE 5
Under the setting condition. Then you can press "SET" button to set hot -air rework station' s temperature and the main temperature area shines the setting temperature, you can press UP knob or DOWN knob to adjust the setting temperature. 4s-no-press or press SET knob, you can keep the temperature and quit out this setting. (Diagram 6). A. Setting temperature via handle of rework station.
PAGE 6
10. Error/Fault indication (diagram 11) 7. Dormancy Under normal working condition, when the user put the handle on the bracket, then the equipment will be automatically switch to the dormancy condition and the heater also stops heating. This happens in the case when the temperature is higher than 100 , during the hot-air station dormancy period the screen A display character SLP (diagram 3) Screen A: Standby 1.
PAGE 7
5.Standby (diagram 17) In normal working condition, press POWER key at the right of panel to make the device be standby (diagram 2). Make the power off, at the same time, the soldering station is off and the whole station will off when the temperature is low to 100 . Standby state of screen B 3.
PAGE 8
E. Insert new heating element in PCB board, pay attention to install properly. F. Install it as the contrary method of remove.
PAGE 9