User's Manual

Version 1.0 ElmoTech Ltd

7. Place the Transmitter on its side on a non-metal table and

wait 30 to 60 seconds, until audible beeping sounds are

heard from the DCU unit. These beeps indicate that the

Transmitter has successfully completed its Calibration

process and is ready to be mounted on the offender.

If a number of Transmitters calibrated at the same

time, it is important to wait for the final beeps to be sure

that the calibration went OK. After the OK confirmation

the next Transmitter can be calibrated.

Attaching the Transmitter

In order to attach the Transmitter to the Offender, do the

following:

1. Flip a strap holder over the short strap of the Transmitter.

2. Attach the female Clip to the underside of the

Transmitter’s short strap (to lie against the Offenders

skin). Verify that the closed end of the clip fits with the

edge of the strap. Make sure the silver line is visible.

DCU & Transmitter Field Installation Manual