User's Manual

ElmoTech Ltd Version 1.0

DCU & Transmitter Field Installation Manual

TRANSMITTER CLEANING

INSTRUCTIONS

The Transmitter is made of a single mold, especially designed

to protect the integrity of the electronic circuits during daily use

and while it is being cleaned.

A soft brush and an Alcohol based solution; soapy water or

Lysol can be used to clean the Transmitter. For additional safety

and user comfort it is recommended that after cleaning with any

of the above, you wash and wipe the Transmitter with clear

water before it is re-used.

Cleaning the Transmitter:

In order to clean the Transmitter, do the following:

1. Remove the "female" clip and rubber band from the short

strap.

2. Holding it at the end of the long strap, spray the

Transmitter with a cleaning solution of choice.

3. Using a piece of cloth or a paper towel, dry the outer side

of the Transmitter. Lay the Transmitter on the towel with

its inner side facing up. Using a soft brush or another

piece of cloth/towel gently scrub the inner side of the

Transmitter along the "tracks".

4. Wash the Transmitter in clear water. Dry the Transmitter

using a piece of cloth/paper towel or simply let it drip dry.