User's Manual

ElmoTech Ltd Version 1.0

5. Put the strap clasp back in place (the wider side pointing

in-wards).

6. Close the screw with the screwdriver. It has to be closed

firmly, but not too tight since this can damage the strap

(maximum allowed torque is 1 Newton x Meter).

7. Test the new strap by performing a calibration (see the

section, Calibrating the Transmitter).

If, after the calibration, the Transmitter does not reset,

repeat steps 1-3 and make sure that the strap is

positioned correctly over the pins. Then repeat steps 5-6

and perform another reset.

If changing one side of the strap does not work, you

should try and change the other strap side according to

steps 1-7.

DCU & Transmitter Field Installation Manual