User's Manual

iDEU-810 Installation and Operational Guide
3. Using the template, drill two holes in the wall and place the supplied
wall anchors/dowels into these holes.
4. Insert the supplied bolts/screws into the wall dowels, ensuring not to
tighten the bolts/screws completely.
5. Holding the Wireless Monitoring Unit with the mounting brackets
facing away from you, maneuver the holes on the mounting brackets
over the bolts/screws already attached to the wall.
6. Pull the mounting brackets down over the bolts/screws slightly to ensure
that the bolts/screws lock into the holes on wall bracket.
7. Using an extension ratchet, tighten the bolts/screws until the Wireless
Monitoring Unit sits firm against the wall and does not move in any
way.
2.2 Temporary Velcro Wall Fitting
The Velcro wall fitting may be used for installing the Wireless Monitoring
Unit in a temporary location (e.g. during pre-installation and range setting
procedures).
In order to mount the Wireless Monitoring Unit using the supplied Velcro
wall fittings, perform the following:
1. Place the Wireless Monitoring Unit on its faceplate with the fixed wall
brackets facing upwards.
2. Peel off the paper strip from the backside (smooth side) of the black
Velcro attachment and press the sticky side down onto the wall bracket.
Do this for both wall brackets.
3. Place the bristle side of the transparent Velcro attachment on top of the
black Velcro attachment and press down firmly, connecting the two
Velcro attachments together.
4. Peel off the paper strip from the backside (smooth side) of the
transparent Velcro attachment.
2-5