User's Manual
Table Of Contents
- SAFETY INFORMATION
- Intended Use:
- Safety information for Trained Customer (e.g., officer, agency representative, ministry of justice) and Offender.
- Safety information for Trained Customer only.
- Safety information for Offender only.
- Default Notification Options
- Finish Enrollment
- Basic Rule Setup
- Finish Enrollment
- 1. Click on the Home Curfew Rule (see below).
- 2. Move your cursor over the Rule Functions menu and left click Edit.
- 3. You will be redirected to the Edit Rule page. Scroll down to the Permanent Rule Schedule.
- You can create an Exclusion Rule to ensure that the offender is not entering areas which are forbidden – such as schools, playgrounds, and victims’ residences.
- 1. Move your cursor over the Rule Functions menu (see below).
- 2. Left click Add Zone.
- 1. Move your cursor over the Hardware Functions menu and left click Unassign.
- 2. Click the checkbox next to the 1 Piece (Gen 4) and Beacon (see below).
- 3. Click on the drop-down menu and select an Unassignment Reason. This is required.
- 4. Click the Save button. A popup will generate with a warning that the unassignment is immediate.
- 5. Click OK.
- 6. You will be returned to the Offender Information page, where the Beacon will be unassigned and the 1 Piece (Gen 4) will be pending unassignment. The 1 Piece (Gen 4) is now required to call 3M Electronic Monitoring and transmit its final data. It wi...
12
1 Piece (Gen 4) Operating Details
LEDs
Power
This LED indicates the condition of the 1 Piece (Gen 4) battery.
Prior to Activation:
Before activating the device, the officer should conduct a battery test. To do this,
simply hold down the silver activation button for three seconds and observe the
condition of the Battery LED.
• If the “PWR” LED is green, there is a sufficient charge to activate the 1 Piece
(Gen 4).
• If the “PWR” LED is red, or does not light up at all, the 1 Piece (Gen 4) needs to
be charged.
After Activation:
• If the “PWR” LED is blinking green, there is a sufficient charge.
• If the “PWR” LED is blinking red, the 1 Piece (Gen 4) needs to be charged.
1 Piece (Gen 4) on Charger:
When the 1 Piece (Gen 4) is connected to the charger, the Power LED will be solid (not
flashing) green or red.
• If the LED is red: The 1 Piece (Gen 4) is not fully charged and should not be
disconnected from the charger
• If the LED is green: The 1 Piece (Gen 4) battery has been completely charged
and the charger may be disconnected
• When the 1 Piece (Gen 4) is connected to the charger, it will vibrate once
indicating a good connection. When the battery is fully charged, the 1 Piece
(Gen 4) will vibrate once indicating that it is okay to remove from the charger.