User's Manual
Table Of Contents
- SAFETY INFORMATION
- Intended Use:
- Safety information for Trained Customer (e.g., officer, agency representative, ministry of justice) and Offender.
- Safety information for Trained Customer only.
- Safety information for Offender only.
- Default Notification Options
- Finish Enrollment
- Basic Rule Setup
- Finish Enrollment
- 1. Click on the Home Curfew Rule (see below).
- 2. Move your cursor over the Rule Functions menu and left click Edit.
- 3. You will be redirected to the Edit Rule page. Scroll down to the Permanent Rule Schedule.
- You can create an Exclusion Rule to ensure that the offender is not entering areas which are forbidden – such as schools, playgrounds, and victims’ residences.
- 1. Move your cursor over the Rule Functions menu (see below).
- 2. Left click Add Zone.
- 1. Move your cursor over the Hardware Functions menu and left click Unassign.
- 2. Click the checkbox next to the 1 Piece (Gen 4) and Beacon (see below).
- 3. Click on the drop-down menu and select an Unassignment Reason. This is required.
- 4. Click the Save button. A popup will generate with a warning that the unassignment is immediate.
- 5. Click OK.
- 6. You will be returned to the Offender Information page, where the Beacon will be unassigned and the 1 Piece (Gen 4) will be pending unassignment. The 1 Piece (Gen 4) is now required to call 3M Electronic Monitoring and transmit its final data. It wi...
45
Activating the 1 Piece (Gen 4), Cont.
.
Step 11:
Press and hold the Activate Button on the top of the 1
Piece (Gen 4) for three seconds.
A. The 1 Piece (Gen 4) will vibrate once and the “PWR”
LED will begin to blink green, indicating the 1 Piece
(Gen 4) is powered on.
B. The “GPS” and “ZONE” LED’s will blink green once
every second. This indicates that the 1 Piece (Gen 4) is
attempting to make a wireless call.
C. The “GPS” and “ZONE” LEDs will blink green twice
every second. This indicates that the 1 Piece (Gen 4) is
attempting to acquire GPS. The 1 Piece (Gen 4) must
now be taken outside to acquire GPS.
D. The “GPS” and “ZONE” LED’s will then blink green
three times every second. This indicates that the 1
Piece (Gen 4) is attempting to communicate with the
Beacon. The offender will be required to move in range
of the Beacon in order to complete the activation
process. The 1 Piece (Gen 4) will vibrate 3 times when
activation is complete.
Note: If no Beacon is present, it will still be possible to
activate the 1 Piece (Gen 4) by holding down the
activation button for approximately five seconds while
the “GPS” and “ZONE” LEDs blink three times. The 1
Piece (Gen 4) will vibrate 3 times when activation is
complete.