User's Manual
Table Of Contents
- SAFETY INFORMATION
- Intended Use:
- Safety information for Trained Customer (e.g., officer, agency representative, ministry of justice) and Offender.
- Safety information for Trained Customer only.
- Safety information for Offender only.
- Default Notification Options
- Finish Enrollment
- Basic Rule Setup
- Finish Enrollment
- 1. Click on the Home Curfew Rule (see below).
- 2. Move your cursor over the Rule Functions menu and left click Edit.
- 3. You will be redirected to the Edit Rule page. Scroll down to the Permanent Rule Schedule.
- You can create an Exclusion Rule to ensure that the offender is not entering areas which are forbidden – such as schools, playgrounds, and victims’ residences.
- 1. Move your cursor over the Rule Functions menu (see below).
- 2. Left click Add Zone.
- 1. Move your cursor over the Hardware Functions menu and left click Unassign.
- 2. Click the checkbox next to the 1 Piece (Gen 4) and Beacon (see below).
- 3. Click on the drop-down menu and select an Unassignment Reason. This is required.
- 4. Click the Save button. A popup will generate with a warning that the unassignment is immediate.
- 5. Click OK.
- 6. You will be returned to the Offender Information page, where the Beacon will be unassigned and the 1 Piece (Gen 4) will be pending unassignment. The 1 Piece (Gen 4) is now required to call 3M Electronic Monitoring and transmit its final data. It wi...
50
Removing the (Gen 4)
Step 1:
Spread the handles of the
strap installation tool and
cut the strap by sliding
the tool upwards until the
strap is positioned inside
the strap removal slot (see
above). Squeeze the
handles firmly until the
strap is cut.
Step 2:
Use a flathead
screwdriver to push on
the tamper plugs and
break them.
Step 3:
Use the screwdriver to
remove the tamper plugs
by pressing down on the
release latch inside the
bracket.