User's Manual
Table Of Contents
- SAFETY INFORMATION
- Intended Use:
- Safety information for Trained Customer (e.g., officer, agency representative, ministry of justice) and Offender.
- Safety information for Trained Customer only.
- Safety information for Offender only.
- Default Notification Options
- Finish Enrollment
- Basic Rule Setup
- Finish Enrollment
- 1. Click on the Home Curfew Rule (see below).
- 2. Move your cursor over the Rule Functions menu and left click Edit.
- 3. You will be redirected to the Edit Rule page. Scroll down to the Permanent Rule Schedule.
- You can create an Exclusion Rule to ensure that the offender is not entering areas which are forbidden – such as schools, playgrounds, and victims’ residences.
- 1. Move your cursor over the Rule Functions menu (see below).
- 2. Left click Add Zone.
- 1. Move your cursor over the Hardware Functions menu and left click Unassign.
- 2. Click the checkbox next to the 1 Piece (Gen 4) and Beacon (see below).
- 3. Click on the drop-down menu and select an Unassignment Reason. This is required.
- 4. Click the Save button. A popup will generate with a warning that the unassignment is immediate.
- 5. Click OK.
- 6. You will be returned to the Offender Information page, where the Beacon will be unassigned and the 1 Piece (Gen 4) will be pending unassignment. The 1 Piece (Gen 4) is now required to call 3M Electronic Monitoring and transmit its final data. It wi...
51
Removing the (Gen 4), Cont.
Step 4:
Keep the release latch depressed as you pull the strap
with attached pin trays out of each bracket. Discard the
tamper plugs, pin trays, and straps.
Note: Do NOT reuse the tamper plugs.
Note: Do NOT remove tamper plugs from the brackets of
the device unless there is a strap with an attached pin tray
inside the bracket.