User's Manual

Monitoring System Maintenance
MEMS 3000 HomeStation and Transmitter Installation Guide
8-2
Cleaning the Transmitter
The transmitting tag is made of a single mold, especially designed to protect
the integrity of the electronic circuits during daily use and while it is being
cleaned. A soft brush and an alcohol based solution; soapy water or Lysol
can be used to clean the transmitter.
For additional safety and user comfort, it is recommended that after
cleaning with any of the above-mentioned solutions, you wash and wipe the
transmitter with clear water before it is re-used.
To clean the transmitter, perform the following:
1. Remove the ‘female’ clip and strap holder from the transmitter short
strap.
2. If the storage clip is on, remove it until you finish cleaning the
transmitter.
3. Holding the transmitter by the end of the long strap, spray the
transmitter with a cleaning solution of choice.
4. Using a piece of cloth or a paper towel, dry the outer side of the
transmitter. Lay the transmitter on the towel with its inner side facing
up. Using a soft brush or a piece of cloth/towel, gently scrub the inner
side of the transmitter along the tracks.
5. Wash the transmitter in clear water.
6. Dry the transmitter using a piece of cloth/paper towel or simply let it
drip dry.
7. Once the transmitter is dry, place it into the specially designed
transportation case.