User's Manual

Monitoring System Maintenance
MEMS 3000 HomeStation and Transmitter Installation Guide
8-4
3. Position the new strap over the transmitter body. Notice that the two
small holes on the strap have to lie exactly over the two metal pins.
4. Gently place the strap down over the metal pins and press down along
the seam of the strap, snugly fitting the entire strap to the transmitter
body.
5. Put the strap clasp back in place with the wider side pointing in-wards.
6. Close the screw (s) with the screwdriver. It has to be closed firmly, but
not too tight since this can damage the strap.
7. Test the new strap by performing a calibration.
If, after the calibration, the transmitter does not reset, repeat steps 1-6
making sure that the strap is positioned correctly over the pins. Then
perform another calibration test. If changing only one side of the strap does
not work, you should try and change the other strap side.