User's Manual

Part Number - 350109601 Revision – A00-000

Wireless Resident Monitoring

Solutions

Emergency Call Button Operational

Instructions

The HomeFree system was designed to monitor special needs and Dementia

individuals in the care center environment. The Emergency Call Button is

one of the many unique elements of this system.

The Emergency Call Button is a small, lightweight push button unit worn by

the resident / nurse that alerts care center staff members whenever the

resident / nurse activates an emergency call alert. The Emergency Call

Button can be worn as a pendent, watch style or clip-on. The Emergency

Call Button is not for use outside the monitored area.

Activating the Emergency Call Button:

The Emergency Call Button is turned off by the manufacturer before

shipment and must be activated before use. To activate, hold the Emergency

Call Button firmly in your hand and press the panic button continuously for

2 seconds. The LED indicator flashes indicating that the Emergency Call

Button is in active mode.

Panic

Button

LED Indicator

PAGE 1
Part Number - 350109601 Revision – A00-000 Wireless Resident Monitoring Solutions Emergency Call Button Operational Instructions The HomeFree system was designed to monitor special needs and Dementia individuals in the care center environment. The Emergency Call Button is one of the many unique elements of this system.
PAGE 2
Part Number - 350109601 Revision – A00-000 Once in active mode, the Emergency Call Button sends a status message to the monitoring station (every 60 minutes) indicating the current battery status as well as the location of the Emergency Call Button. This status message is sent until the Emergency Call Button is deactivated. Activating a Panic Alert Press the panic button. The LED indicator flashes indicating that the Emergency Call Button is in panic alert mode.
PAGE 3
Part Number - 350109601 Revision – A00-000 FCC Notices Note: The following is applicable only to the 318MHz version of this product. FCC ID: QUX-PB-830 FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 STATEMENT The equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.