Personal Watcher™ Operating Instructions Red Light Indicates ON/OFF Adjusts time ON/OFF Button Metal Clip secures
Operating Instructions About the Personal Watcher™ Unit The Personal Watcher™ (Watch Style) is a uniquely designed wristwatch and wander-monitoring device. Lightweight and water-resistant, it is worn by the monitored individual at all times. The Wireless Monitoring Unit (WMU) network picks up its silent, continuously active signal, alerting staff members whenever a monitored individual enters or exits a restricted zone, approaches a monitored door or exit, or removes the device.
Operating Instructions Turn On PW The PW can only be turned on if the strap is completely open and the back of the PW does not detect heat. 1. Open the watchstrap. Hold the PW so that you are not touching the back of the device (body sensor) and the straps do not touch each other. Press and hold the ON/OFF button until the Red Light on the watch face turns on and off briefly. 2. IMMEDIATELY put the watch down on its side on a non-metal surface, near the central monitoring computer.
Operating Instructions Turn Off PW PWs should be turned off when not in use, for example, when a resident is in the hospital or discharged from the facility. A PW can only be turned off if its strap is completely open and the PW back does not detect heat. 1. Open the PW strap. Press and hold the ON/OFF button until the Red Light on the watch face turns on. 2. Release the ON/OFF button, and then quickly press the button twice. The Red Light turns on for 1-2 seconds and then turns off again.
Operating Instructions FCC Notices The PW-830-2 complies with Part 15 of the FCC Rules. Operation issubjectto the following conditions: 1. This device may not cause harmful interference and 2. This device must accept any interference received, including interference that may cause undesired operation. 3.
Personal Watcher Page 5 of 5
