User's Manual

E3 Receiver Unit and Transmitter Installation Guide
4. Hold the electronic key and the Transmitter strap in this
position while you perform the next step.
5. Press the ‘ON’ on the electronic key for one second; the red
LED light on the electronic key turns steadily on for two
seconds. If the Transmitter successfully received the
activate/calibrate commands the red light on the electronic
key will flash for two seconds.
Note: If the Transmitter failed to receive the
activate/calibrate command, the red light on the electronic
key will turn off after the initial two seconds on. If the
electronic key’s battery is low, the red light will immediately
flash for two seconds once the ‘ON’ button is pressed.
6. Place the Transmitter on its side, on a non-metal table and
wait for about thirty seconds.
To deactivate the Transmitter, simply follow the instructions
from steps 1 to 6 above, but instead of pressing the ‘ON’ button
on the electronic key to activate/calibrate the Transmitter, press
the ‘OFF’ button.
4