Ankle Tag TXL-700 USER MANUAL 10 December 2002
ElmoTech Ltd. TXL-700 - User Manual Table of Contents 1. Foreword ....................................................................................2 2. Installing the Ankle Tag. ...........................................................3 3. General Rules for the Client ......................................................6 4. 4.1. 4.2. Maintenance Instructions...........................................................7 Cleaning the Ankle Tag ....................................................
ElmoTech Ltd. TXL-700 - User Manual 1. Foreword The Ankle Tag (TXL-700) is a transmitter used in home arrest systems. The Ankle Tag (LSQ-TXL-700) is transmitting on an American FCC tested and approved frequency; whereas the European version (TXL-700-2) is transmitting on a European tested and approved frequency. From a user interface and function point of view the two models are identical; therefore this user manual serves both versions.
ElmoTech Ltd. TXL-700 - User Manual 2. Installing the Ankle Tag. Hold the transmitter in your hand with the 4 metal pins (2 pairs, along the strap) pointing forward. Hold the Electronic Key in your other hand, with the black button pointing toward the open or free end of the strap. Press the Electronic Key down over one pair of metal pins (it does not matter which) with the two touch points on the Electronic Key matching the pair of metal pins on the Transmitter strap.
ElmoTech Ltd. TXL-700 - User Manual Place the Tag on its side, on a non-metal surface, for 30 seconds. Attaching the Transmitter Place a strap holder over the short strap (strap with pin side) of the Transmitter. Attach the female Clip to the underside of the Transmitter’s short strap (to lie against the Offenders skin). Check that the closed end of the clip fits with the edge of the strap and make sure the silver line is visible.
ElmoTech Ltd. TXL-700 - User Manual Ask the Offender to stand up and move around to insure that the Tag is comfortable. Fasten the two Clips with the locking tool. Be sure to fasten all the four pins well. An audible clicking sound should be heard, indicating that the Clips are closed properly. Don’t install the Tag over a thick sock, since the Tag will get too loose once the sock is removed.
ElmoTech Ltd. TXL-700 - User Manual 3. General Rules for the Client The Transmitter is a waterproof wristwatch and there is no need to remove it when taking a bath or a shower. You can even wear it when swimming and diving in a swimming pool or taking a sauna bath. Turn the Transmitter’s transmission off when admitting to a hospital, either for a visit or for hospitalization, since the transmitted signal may affect other medical instrumentation.
ElmoTech Ltd. TXL-700 - User Manual 4. Maintenance Instructions 4.1. Cleaning the Ankle Tag A soft brush and any cleaning solution are all that is needed to clean the Ankle Tag TXL-700. Alcohol based solutions; Soapy water or Lysol can be used to clean the Tag. For additional safety and user comfort it is Recommended that after cleaning with any of the above the Tag be washed with clear water before it is reused.
ElmoTech Ltd. 4.2. TXL-700 - User Manual Ankle Tag Straps Replacement Possible reasons for a replacing a strap could be: • Visible damage to one or both straps. • Reception of strap tamper alarms, with no visual reason seen. • Tag does not calibrate. Turn the Tag off with the electronic key. Using the supplied snake eye screwdriver, open the screw that holds the strap clasp and remove the strap clasp. Gently shake the strap loose from the Tag body.
ElmoTech Ltd. TXL-700 - User Manual Activate the Tag with the electronic key, close the strap and test for “strap closed” message reception.
ElmoTech Ltd. TXL-700 - User Manual 5. FCC Notices Inside plastic body situated “Loaded” antenna, which connected to PCB by 1cm wire. This note is applicable to the American Ankle Tag (LSQ-TXL-700) NOTE The Ankle Tag TXL-700 complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
ElmoTech Ltd. TXL-700 - User Manual • Increase the separation between the equipment and the receiver. • Consult the dealer or an experienced radio/TV technician for help. CAUTION Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment. For Customer Support contact: ElmoTech Ltd. Corporate Headquarters P.O. Box 13236, 2 Ha-Barzel St.
