User guide

Control Center
User Manual
 Attero Tech LLC 2013 Page 1 614-00002-07
1 – Overview
Attero Tech Control Center is an easy to use configuration and monitoring application for CobraNet devices. As well as
being usable for configuring the generic parameters of any CobraNet device, such as the bundle setup for audio routing or
serial bridge functionality, it also includes device specific setup for Attero Tech products such as the VoiceBox 4 I/O and the
InBox and OutBox products.
*Note: Whilst devices from manufacturers other than Attero Tech are detected and displayed, use the manufacturers’ own
software to set up their devices. Using Control Center to control a device from another manufacturer is at the user’s own
risk. Attero Tech bears no responsibility for the results if settings are altered on a non-Attero Tech CobraNet device.
1.1 – How to Use Attero Tech’s Control Center
This manual is designed to give the user a guide on how to use the Attero Tech Control Center to view and control CobraNet
devices on a network. The steps required to use the software are as follows:
o Install the application (see section 2)
o Run the application (section 3)
o Configure the network adapter (see section 3.1)
o Select a device to view its properties
o Configure the devices system parameters (if needed)
o Configure the devices audio routing and bundle setup (if needed)
o Configure the devices setup (Attero Tech devices only)
This manual also includes an introduction to CobraNet in the appendices for those who are unfamiliar with CobraNet.