Specifications

Using Help | Contents | Index

Shadow Tracker ™ Professional

Premier Base - Help

Using Help | Contents | Index

SHADOW TRACKER JR., J2, PRO AND PERFORMER

To connect the ignition cable:

1 Connect the Ignition Cable into the Ignition Cable connector on the Tracking Unit. The

Ignition Cable connector is the 3” wire protruding from the back of the Unit.

2 Next, connect the Ignition Cable’s RED wire into the vehicles ignition system.

MPORTANT: To work properly, Step 2 must be made at a place where active voltage is on only

when the ignition is on.

DC Direct Connect Cable

Instead of using the DC Power Adapter, you might prefer to have the Tracking Unit connected

directly to the vehicle’s power supply. If this is the case, an optional DC Direct-Connect Cable

is available. Installing a Direct Connect Cable is referred to as hardwiring. Hardwiring eliminates

the possibility of GPS data not being collected due to a loose DC Power Adapter connection, or

because an employee simply forgets to plug the adapter in.

To install the direct connect cable:

Shadow Tracker Jr., Pro, Performer

1 Connect the DC Direct-Connect Cable’s

BLACK w/ stripe wire to a 12-volt

positive power source.

IMPORTANT: This connection must be made at a place where power is supplied even when the

vehicle is turned off.

2 Connect the cable’s remaining black wire to a ground source.

3 Connect the other end of the DC Direct Connect Cable into the power connection labeled

, located on the side of the Tracking Unit.

Shadow Tracker j2

1 Connect the DC Direct-Connect Cable’s

BLACK w/ stripe wire to a 12-volt

positive power source.

IMPORTANT: This connection must be made at a place where power is supplied even when the

vehicle is turned off.