- ATTO iPBridge Operation Manual

iv
CLI error messages
The following error messages may be returned by the Command line Interface
ERROR. Invalid Command. Type 'Help' for command list.
ERROR. Wrong/Missing Parameters
Usage: <usage string>
CLI summary
The following chart summarizes the Command
Line Interface commands, their defaults, and an
example of how to enter the commands.
Commands which have no default values have a
blank entry in that column of the table.
CAUTIONCAUTION
Do not use CLI unless you are directed to by an ATTO technician.
Changing parameters may cause loss of data and/or disruption to performance and reliability of
the iPBridge.
The ExpressNAV interface is the preferred method to operate and manage the iPBridge. Refer to
Interface options on page 23 for details.
Command Default Example
AccessControl disabled for default node
enabled for all other nodes
set accesscontrol default enabled
AccessEntry set accessentry discovery all delete
AutoMap automap
AutoMapOnBoot enabled set automaponboot disabled
AutoMapOnBootDelay 0 set automaponbootdelay 20
BridgeModel get bridgemodel
BridgeName iPBridge set bridgename Omega6
ClearEventLog cleareventlog
Date set date 03/03/2003
DeleteAllMaps deleteallmaps
DPMTU 1514 set dpmtu 9014
DumpConfiguration dumpconfiguration
DumpEventLog dumpeventlog
EthernetSpeed auto set ethernetspeed dp1 100
Exit exit
FirmwareRestart firmwarerestart
Help help automap
IdentifyBridge disabled set identifyBridge enabled
Info info
IPAddress 10.0.0.1 get ipaddress dp1
IPDHCP enabled set ipdhcp dp1 disabled
IPGateway 0.0.0.0 get ipgateway dp1
IPSubnetMask 255.255.0.0 get ipsubnetmask dp1
iSCSIAlias “ “ set iscsialias diamond
iSCSIChap disabled set iscsichap default enabled