- ATTO FibreBridge Operation Manual

xiv
SNMPTrapAddress
Sets/displays the IP trap addresses and levels.Consult
your network administrator for further assistance with
SNMP.
Index: value between 1 and 6
IPAddress: standard IP address for the host receiving
messages; must be in the same subnet as the
FibreBridge
Trap Level: severity required for an event to trigger a
trap:
None: no traps are sent to the address
ALL: all triggering events are sent
Warning: warning and critical events are sent
Critical: only critical events trigger a trap
Default: 0.0.0.0 none
set SNMPTrapAddress [Index] [IPAddress] [None | All |
Warning | Critical ]
get SNMPTrapAddress [index]
SNMPTraps
Controls SNMP trap functions.Consult your network
administrator for further assistance with SNMP.
Default: disabled
set SNMPTraps [enabled | disabled]
get SNMPTraps
SNTP
Controls whether the FibreBridge contacts a specified
SNTP time server to initialize or synchronize the time.
Default: enabled
set SNTP [enabled | disabled]
Requires a SaveConfiguration Restart command
get SNTP
SNTPServer
Controls/displays the main IP address of the SNTP time
server. If the FibreBridge is unable to contact the
specified SNTP timeserver within 30 seconds, the
FibreBridge tries to contact the first auxiliary SNTP time
server. If not successful, the FibreBridge tries to contact
the second auxiliary server. If not successful, the
FibreBridge continues to keep time based on the most
recent SNTP time server, physical RTC or manual
initialization or synchronization
Default: 192.43.244.18 (time.nist.gov)
set SNTPServer xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get SNTPServer
SpeedWrite
SpeedWrite is a method to improve the performance of
WRITE commands to SCSI tape devices attached to the
FibreBridge. You can specify the SCSI bus, target and
LUN of a mapped device or specify
all to control the state
of all currently mapped SCSI devices.
Default: all disabled
set SpeedWrite SCSI [sb st sl | all] [enabled | disabled]
Requires a SaveConfiguration command
get SpeedWrite SCSI [sb st sl | all]
SpeedWriteDefault
Specifies the state of SpeedWrite for any SCSI devices
mapped manually or using an
AutoMap command. If
enabled, any new SCSI device uses
SpeedWrite
automatically.
Default: disabled
set SpeedWriteDefault [enabled | disabled]
Requires a SaveConfiguration command
get SpeedWriteDefault
TailEventLog
Displays new events to the terminal. Type quit
and press Enter to exit .
TailEventLog
Temperature (FB2390, FB2400 only)
Displays the current internal temperature of the
FibreBridge in degrees Celsius.
get Temperature
Time
Controls/displays the time in a 24-hour format. The
default time is 00:00:00 and is accurate until the
FibreBridge is reset or power-cycled when it returns to
the default.
Time cannot be set if SNTP is enabled.
Default: 0:00:00
set Time [HH :MM :SS]
Requires a SaveConfiguration command
get Time