Setup guide

Chapter 3 Assembling the System
48
8 PB, ANALOG OUT
(component)
SD analog component video output, PB color difference signal, BNC
connector; connects to B-Y video input of decks. The component
analog output connectors can also be connected to a monitor or
waveform/vector.
9 PR, ANALOG OUT
(component)
SD analog component video output, PR color difference signal, BNC
connector; connects to R-Y video input of decks. The component
analog output connectors can also be connected to a monitor or
waveform/vector.
10 CV 1, ANALOG OUT
(composite)
Composite video output, BNC connector. Connects to analog video
input of decks or monitor.
11 CV 2, ANALOG OUT
(composite)
Composite video output, BNC connector. Connects to analog video
input of decks or monitor.
12 S-VIDEO, ANALOG OUT Super-video output, 4-pin connector. Connects to analog video input
of decks.
13 SDI IN Serial Digital Interface input, BNC connector.
14 SDI OUT1 Serial Digital Interface output number 1, BNC connector.
15 SDI OUT2 Serial Digital Interface output number 2, BNC connector.
16 DAE Digital Audio Extraction (DAE) interface, 9-pin DSUB connector.
DAE will not be supported in the initial release of the Nitris DNA.
17 SYSTEM Audio, video, and communication I/O connector from the Avid DS
system.
18 LTC IN Longitudinal timecode input, female connector. Can be used in place
of 9-pin deck control when deck control is not required.
19 LTC OUT Longitudinal timecode output, male connector. Master clock used to
stripe tapes and synchronize systems to the house master clock
(SMPTE for NTSC, and EBU for PAL).
20 Monitor OUT 1 1/4-inch audio tip/ring/sleeve (TRS) jacks that each output one
channel (left/right) of audio to speakers. The audio feeding this
connection is from the incoming or outgoing audio.
c
This TRS jack provides balanced professional level audio to
your speaker system. Do not use 1/4 mono cables in this
connector, your output levels might be too high.
21 Monitor OUT 2
SD Video I/O Board Identifiers (Continued)
Number Label Function