Specifications
33
ATTO Technology FibreBridge 4500 Installation and Operation Manual
FcSCSIBusyStatus
Specifies the SCSI status value returned when the FibreBridge is unable to accept a SCSI command because of a temporary lack
of resources.
Limits: [busy | qfull] Default: busy
Actions:
set FcSCSIBusyStatus [busy | qfull] I
nformation:
get FcSCSIBusyStatus
SaveConfiguration
FcTargets
Obtains information about every Fibre Channel target device visible to a FibreBridge operating in initiator mode; devices may be
used as targets for initiator mode features such as Extended Copy.
Actions:
none
Information:
FcTargets
Returns: Node Name, FC LUN & inquiry data for each FC device found
FcWWName
Reports the Word Wide Name (WWN) of the Fibre Channel interface. Each FC port has an individual and unique WWN. The least
significant 6 bits of the WWN are used as the Ethernet MAC address.
Limits: Fabric and loop operations are unpredictable if duplicate WWNs are assigned.
Actions:
none
Information:
get FcWWN [PortNumber]
Return: Port n FcWWName= 20 00 00 10 86 nn nn nn
FibreBridgeTargetLUN
Specifies the soft target LUN(s) to be used by the FibreBridge when addressed by the host as a SCSI device.
Limits: Any map coinciding with the user-specified FibreBridgeTarget LUN must first be set to offline before trying to change it. This
map will be destroyed upon power-cycling the FB.
Disabling a FibreBridgeTargetLUN for a particular FC port will destroy the map to the FB4500 for that port.
The get form reports all FibreBridgeTargetLUNs currently NOT disabled. Specifying a port returns the status of that port.
Action:
set FibreBridgeTargetLUN [fp] [fl] | [disabled] ]
Information:
get FibreBRidgeTargetLUN <[fp]>
SaveConfiguration
Returns:
[Line Count]
[fp] [fl]
Performance
Returns the performance data for the Fibre Channel port you specify. Data includes the average rate (MBs per sec.) and number
of I/Os measured over the previous sampling period where a sampling period is approximately one second. Requesting
performance data for an FC port which has been disabled or has failed will result in the display of an error message (“ERROR
Disabled Fibre Channel port” or “ERROR Failed Fibre Channel port”). Reported performance may be affected by FC port and
SCSI bus availability and saturation, SCSI device speeds and overall system use.
Limits: Successful SCSI Read (08h, 28h) and Write (0Ah, 2Ah) commands are considered I/Os.
Valid FC port (fp) entries are [0|1|2]
Actions:
none
Information:
get Performance <fp>
Verbose return:
[line count]
; fp
.
MB/s
.........
IO/s
[fp] [mmm.mmm] [nnn]
ServicesLUN
Specifies the Services LUN(s) to be used by the FibreBridge during an “inband” CLI session with a given host as taken from
NVRAM..
Limits: Any map coinciding with the user-specified ServicesLUN must first be set to offline before trying to change it. This map will
be unavailable upon power-cycling the FibreBridge.
The get form reports all ServicesLUNs currently NOT disabled. Specifying a port returns the status of that port.
Default:0x08
Action:
set ServicesLUN [fp] [fl] | [disabled] ]
Information:
get ServicesLUN <[fp]>
SaveConfiguration
Return:
[Line Count]
[fp] [fl]