Specifications
37
ATTO Technology FibreBridge 4500 Installation and Operation Manual
FcConnMode
Controls/reports the connection mode the FibreBridge uses when communication across a Fibre Channel network, either to an arbitrated loop
(FC-AL) when you select
loop
mode, or point-to-point when you choose
ptp.
Limits: applies to all Fibre Channel ports Default: loop
Actions:
set FcConnMode [loop | ptp]
Information:
get FcConnMode
SaveConfiguration
FcHard
Used to enable or disable Fibre Channel hard address assignment. Under soft addressing, the FibreBridge loop address is assigned
during loop initialization. Use
FcHardAddress
(described below) if you enable hard addressing.
Limits: applies to all Fibre Channel ports Default: enabled, or hard addressing
Actions:
setFcHard [enabled | disabled]
Information:
get FcHard
SaveConfiguration
FcHardAddress
Sets/displays the value used as the FC-AL hard address. This hexadecimal value represents the address the FibreBridge will try to
use if hard addressing is enabled. When an optional address is not present, the current value is displayed.
Limits: Each port has individual hard address value. Default: 3 (Fibre port 0) 4 (port 1) 5 (port 2)
0 < = hard id < = 0x7d
Actions:
set FcHard Address [fp |[address]]
Information:
get FcHardAddress [fp]
SaveConfiguration
verbose return: Port n FcHardAddress = 0x01
FcPortFailure
Controls the behavior of a FC port when the FibreBridge is operating in AddressMap B. (failover) mode.
Limits: [Recover] will reset the FibreBridge to its pre-failover state. the recover mode must be past the index of the failed FC port
[Force] will create one of three types of simulated port failure on the specified active FC port for testing and demonstration.
.....
[loopdown] loss of FC synchronization (pulled cable, bad GBIC, etc.)
.....
[portdown] simulates ISP chip hardware failure as detected by a fabric
.....
[Isperr] simulates an internal ISP chip fatal error
Actions:
set FcPortFailure fp [recover| force [loopdown
| portdown | isperr] ]
Information:
none
FcTargets
Obtains information about every Fibre Channel target device visible to a FibreBridge operating in initiator mode; devices may be
used as targets for initiator mode features such as Extended Copy.
Actions:
none
Information:
FcTargets
Returns: Node Name, FC LUN & inquiry data for each FC device found
FibreBridgeTargetLUN
Specifies the soft target LUN(s) to be used by the FibreBridge when addressed by the host as a SCSI device.
Limits: Any map coinciding with the user-specified FibreBridgeTarget LUN must first be set to offline before trying to change it. This
map will be unavailable upon power-cycling the FibreBridge.
The get form reports all FibreBridgeTargetLUNs currently NOT disabled. Specifying a port returns the status of that port.
Action:
set FibreBridgeTargetLUN [fp] [fl] | [disabled] ]
Information:
get FibreBridgeTargetLUN <[fp]>
SaveConfiguration
Returns:
[Line Count]
[fp] [fl]
RouteChange
Maps a Fibre Channel port and LUN to a SCSI bus, target and LUN. A port being used as a failover port in AddressMap B mode
may not be modified.
Limits: Attempts to map to a SCSI device currently online results in an error message
Valid entries: fp (0-2), fl (0-31), sb (0-3), st (0-15), sl (0-7)
Action:
RouteChange [fp] [fl] [sb] [st] [sl]
Information:
none