Specifications
38
Mapping commands
RouteDisplay
Returns a list of currently mapped Fibre Channel-to-SCSI routes sorted by Fibre Channel address and assembled according to the
optional parameters specified. Each list is preceded by a count of the lines that immediately follow.
Valid status values are: Online, Offline, Unavailable, Available, Mapped, Unmapped, FibreBridge, and All.
Action:
none
Information:
RouteDisplay
Displays all current maps
RouteDisplay [ fp]
Displays specified FC port maps
RouteDisplay [status]
Displays all maps with route status
[online|offline]
RouteDisplay [fp [fl]]
Displays the current map of fp & fl
RouteDisplay [fp [status]]
Displays all maps for a given FC port with
route status [online|offline]
Returns:
[line count]
[fp] [fl] [sb] [st] [sl] [Online|Offline|Unavailable|Available|
Unmapped|FibreBridge|ALL]
RouteOffline
Sets a route to offline or reports its status as offline or going offline. A port being used as a failover port in AddressMap B mode
may not be modified.
Action:
set RouteOffline [fp] [fl]
Information:
get RouteOffline [fp]
Returns: [fp] [fl] [sb] [st] [sl] [Going offline|Offline]
RouteOnline
Sets a route to online or reports its status. A port being used as a failover port in AddressMap B mode may not be modified.
Limits: if route is not currently mapped, command results in an error message
Action:
set RouteOnline [fp] [fl]
Information:
get RouteOnline [fp]
Returns: [fp] [fl] [sb] [st] [sl] [Online|Offline]
ScsiTargets
Returns a list of SCSI devices operational on the referenced SCSI port.
Action:
none
Information:
ScsiTargets [sb]
Returns: [line count]
[sb] [st] [sl] [device type] [vendor ID] [product ID] [revision] [serial
number]
ServicesLUN
Specifies the Services LUN(s) to be used by the FibreBridge during an “inband” CLI session with a given host as taken from
NVRAM..
Limits: Any map coinciding with the user-specified ServicesLUN must first be set to offline before trying to change it. This map will
be unavailable upon power-cycling the FibreBridge.
The get form reports all ServicesLUNs currently NOT disabled. Specifying a port returns the status of that port.
Default: 8 (all FC ports)
Action:
set ServicesLUN [fp] [fl] | [disabled] ]
Information:
get ServicesLUN <[fp]>
SaveConfiguration
Return:
[Line Count]
[fp] [fl]