User manual

- 47 -
Figure 3.6.7.3
5. Select “/ Volume configuration / Virtual disk”.
6. Click “ ”.
7. Input a VD name, choose a RG Name and enter a size of VD; decide
the stripe high, block size, read/write mode and set priority, finally click
“ “.
8. Done. A VD has been created.
9. Do one more time to create another VD.
Figure 3.6.7.4
(Figure 3.6.7.4: Create VDs named “VD-R5-1” and “VD-R5-2”. Regarding to “RG-R5”, the
size of “VD-R5-1” is 50GB, the size of “VD-R5-2” is 64GB. “VD-R5-1” is initialing about 86%.
There is no LUN attached.)
Step 3: Attach LUN to VD.
There are 2 methods to attach LUN to VD.
1. In “/ Volume configuration / Virtual disk”, mouse moves to the gray
button next to the VD number; click “Attach LUN”.
2. In “/ Volume configuration / Logical unit”, click
“
”.
The procedures are as follows:
1. Select a VD.