User manual

- 83 -
Figure F.1
The MPIO setup instructions are in the following:
1. Create RG/VD, and then attach LUN.
2. Add the first “Target Portal” on Microsoft iSCSI initiator.
3. Add the second “Target Portal” on Microsoft iSCSI initiator.
4. Logon.
5. Enable “Enable multi-path” checkbox. Then click “Advanced…”.
6. Select the first “Source IP” and “Target Portal” to iSCSI data port 1.
Then click “OK”.
7. Logon again.
8. Enable “Enable multi-path” checkbox. Then click “Advanced…”.
9. Select the second “Source IP” and “Target Portal” to iSCSI data port 2.
Then click “OK”.
10. iSCSI device is connected. Click “Details”.