User's Manual

15
ATTO Technology Inc. FastStream VT 5300 Installation and Operation Manual
message; it cannot respond to a rejection by a
server for an invalid address. Ensure all E-mail
addresses typed in are valid.
Each E-mail is time stamped when it leaves as
part of the SMTP header information as shown in
Exhibit 3.0-1.
1 If you are not already in the FastStream GUI,
type the IP address of your appliance, as found
in
Use the FastStream VT 5300 GUI on page
23, in a standard browser, click Enter Here and
type in your username and password.
2The Monitor VTL page appears. On the menu
at the left hand side of the page, choose
Manage.
3The Manage VTL page appears. Click on the
FastStream arrow.
4 Click the Set up Error Notification button
5 Click Next.
6 Click on the Enabled button for Notification
Configuration
7 Type in the sender address (E-mails show this
name in the From field)
8 Type in the SMTP Server IP Address
9 Type in the Username and Password of your
SMTP E-mail account
10 Type in up to five E-mail addresses
11 Choose All, Critical or Warning for each E-
mail address.
12 When all information is typed in, click Commit.
13 Your settings are displayed. You may change
or disable E-mail notification at any time from
the Error Notification page.
Exhibit 3.0-1 The E-mail messages sent by the FastStream VT 5300 follow this format.
Subject: [The Type of Event that Occurred]
Message Body:
This is a status message from [FastStream name]. Identifying information as well
as the most recent entries from the event log appear below.
*************** Unit Information ***************
Serial Number : [Serial Number]
IP Addresses: [IP Address1]
[IP Address2]
*************** Event Log Entries ****************
[Listing of the ten latest event log entries]
Measure drive performance
CAUTIONCAUTION
New performance data is updated every 60
seconds which impacts performance
slightly, even if you minimize the browser
window. Exit the browser GUI completely
whenever you need maximum
performance.
The FastStream VT 5300 collects various metrics
to measure performance for physical drives
attached to the FastStream during normal system
operation and drive initialization and verification.
1 If you are not already in the FastStream GUI,
type the IP address of your appliance, as found
in
Use the FastStream VT 5300 GUI on page
23, in a standard browser, click Enter Here and
type in your username and password.
2The Monitor VTL page appears. On the menu
at the left hand side of the page, click on
Diagnostics.
3The Diagnostics Menu page appears. Select
Drive Performance and Health.
4 Click Next.
5The Drive Performance and Health page
appears. Click on a drive in the drive section.
6 Click Start.
7 Drive performance is displayed under the Drive
Metrics section of the page.