Instruction manual

5
ATTO Technology Inc. FastStream SC 5700 Installation and Operation Manual
2.0 Installation
If you have not already completed the instructions on the Quick Start page packed with your FastStream
SC 5700, use the following instructions to install the FastStream SC 5700.
Unpack the packing box; verify contents
• The FastStream. Note the serial number of your
FastStream unit: ________________________
• Power cord
• “L” brackets for mounting in a 19” rack
• CD which includes the Firmware, Installation
and Operation Manual, QuickNAV IP discovery
program and system drivers
Install the FastStream
1 Place the FastStream SC 5700 on a stable flat
surface or install it into a standard rack.
If installing into a rack, see Exhibit 2.0-1.
a. Attach “L” brackets so that the front side
with the LEDs face front and the connector
side is at the back.
b. Install the FastStream horizontally within
the rack so it does not reduce the air flow
within the rack.
2 Connect the host computer to Fibre Channel
port 1 or 2 (see Exhibit 2.0-2).
3 Connect Fibre Channel devices from your SAN
to the FastStream ports 3 and 4 (see
Exhibit 2.0-2).
4 Add power to the devices.
Note
When connecting to the Fibre Channel ports,
use SFPs and multimode fiber optic cables.
Keep cable lengths as short as possible to
ensure the highest signal quality and
performance. Refer to
Fibre Channel ports on
page 3.
5 Connect the Ethernet port to your network.
6 Connect the AC power cord from the
FastStream to the proper AC source outlet.
CAUTIONCAUTION
The power source must be connected to a
protective earth ground and comply with
local electrical codes. Improper grounding
may result in an electrical shock or damage
to the unit.
If you are using a rack, the power requirements
plus the power draw of the other equipment in
the rack must not overload the supply circuit
and/or wiring of the rack.
7 Use the power switch to turn on power to the
FastStream
8 Wait up to two minutes for the FastStream
Ready LED to light indicating the FastStream
has completed its power-on self test sequence.
9 Windows
® users continue to Install Windows
drivers ; Mac ® users continue to Discover the
IP address
Install Windows drivers
1 Windows automatically detects the FastStream
SC 5700 and ask for the driver in the Add
Hardware wizard. Select Install from a list or
specific location
2 Click Next
3 Choose Don’t Search
4 Click Next
5 Choose Have disk
6 Specify the driver as found in the PC folder in
the setup CD. The files are in a folder based on
your operating system: Win2K drivers for
Windows 2000 and Windows XP; Win2K3
drivers for all 2003 Server products.
Note
Use the files directly from the CD or copy them
onto a floppy or to a local directory on your
hard drive.
7 Follow the remaining instructions to complete
the installation procedure.
8 After the driver is installed, FastStream is listed
in the System Devices folder.
Discover the IP address
Note
The FastStream SC 5700 is initially configured
with DHCP enabled. It is best if you have
access to a DHCP server.
1 Work from the computer attached to the
FastStream SC 5700 Ethernet port on the same
broadcast domain. From the CD supplied with
your FastStream, run the QuickNav Utility
QuickNAV-windows.exe for Windows or
QuickNAV-Mac for Mac OS X.
2 Locate the FastStream with the serial number
recorded earlier.
3 Highlight the serial number.
4 Click Next.