Instruction manual

6
If a DHCP server is available on your network,
an address is assigned automatically by the
server. Note the assigned address:
_____________________________________
If you do not have a DHCP server, get an IP
address and subnet mask from your network
administrator, type it into the area provided, and
select Next.
5 Click on Launch Browser
6 Click on Launch Browser
Your browser points to the ATTO ExpressNAV
splash screen. If you use Internet Explorer as a
browser, continue on to Internet Explorer setup
below. If not, continue on to Begin initial
configuration .
Internet Explorer setup
1 Open your browser
2 Select Internet Options.
3In the Internet Options screen, select the
Security tab.
4 Click on the Trusted Sites icon.
5 Click on the Sites button.
6 In the text box Add this Web site to the zone,
add the IP address of the appliance. You may
use wild cards.
7 Click on Add
8 Uncheck the Require server verification
check box.
9 Click OK.
10 At the bottom of the Internet Options box,
click on OK and close the box.
Begin initial configuration
1 The ExpressNAV interface welcome screen
appears. Click on Enter Here
2 Type in the user name and password.
Note
The default user name is root; it is case
insensitive. The default password is
Password ; it is case sensitive. It is best
practice to change the passwords. Refer to
Optional changes to system configurations
on page 15.
3The Initial Setup page appears.Continue to
Configure RAID
on page 7
Exhibit 2.0-1 Connecting the FastStream SC 5700 into a rack
Exhibit 2.0-2 FastStream SC 5700 connections