Instruction manual

26
Update RAID configuration data
If you move single drives between devices
without erasing the drives, you may want to clean
stale RAID configuration data from the drives,
permanently removing the drive from the
previous RAID group. Drives must belong to a
RAID group now or have once belonged to a
RAID group and are labeled Replaced after
system scans.
CAUTIONCAUTION
Continue with extreme caution: data is lost
on the drive when it is cleaned of RAID
information.
1 Follow the instructions in Preliminary steps on
page 23.
2 Click the Diagnostics button on the Menu
Items list on the left hand side of the
ExpressNAV interface.
3 Click in the Clean RAID Configuration data
radio button.
4 Click Next
5 Click on the drives you wish to update; the
drives are highlighted.
6 Click on Commit
7 A warning box appears. In the warning box,
verify that you want to complete the
configuration by clicking on Yes. Clicking on No
ends the procedure without making a change.
8 When the process is complete, the Health and
Status Monitor screen appears
Note
To clean Hot Spare information from a drive,
use the instructions in
FastStream process:
add or remove Hot Spares on page 25.