Instruction manual

x
Exit
Exits the current Ethernet telnet CLI session; it has no
effect if used during a serial or in-band CLI session.
Exit
FCConnMode
Controls/reports the connection mode the FastStream
uses when communication across a FC network, either to
an Fibre Channel Arbitrated Loop (FC-AL) when you
select
loop mode, or point-to-point when you choose ptp .
If you choose
loop-ptp or ptp-loop , the FastStream tries
to use the first parameter first.
Default: loop
set FCConnMode [fp | all] [loop | ptp | loop-ptp | ptp-loop]
Requires a SaveConfiguration command
get FCConnMode [fp | all]
FCDataRate
Specifies the Fibre Channel rate the FastStream uses, 1
Gigabit/sec., 2 Gigabit/sec. 4 Gigabit/sec. or auto
negotiate.
Default: auto
set FCDataRate [fp| all] [1Gb | 2Gb | 4Gb | auto]
Requires a SaveConfiguration command
get FCDataRate [fp | all]
FCHard
Used to enable or disable FC hard address assignment.
Under soft addressing, the FastStream loop address is
assigned during loop initialization.If you enable hard
addressing use
FCHardAddress (described below).
Default: disabled
set FCHard [enabled | disabled]
Requires a SaveConfiguration command
get FCHard
FCHardAddress
Sets/displays the value used as the FC-AL hard address.
This hexadecimal value represents the address the
FastStream tries to use if hard addressing is enabled.
When an address is not set, the current value is displayed.
The valid range of values is 0 through 125.
Default fp1=3; fp2=4 fp; fp3=5; fp4=6
set FCHard Address [fp | all] [address]
Requires a SaveConfiguration command
get FCHardAddress [fp | all]
FCMultiNode
When enabled (multi node), each port reports a separate
unique Node Name and logical units may be mapped to
either port. When disabled (single node), each port
reports the same Node Name and each logical unit
mapping is applied to all ports.
set FCMultiNode [enabled | disabled]
get FCMultiNode
FCPortErrors
Displays the number of Fibre Channel errors that have
occurred since the last reboot/power-on or
ResetFCPortErrors .
get FCPortErrors [fp | all]
FCPortList
Returns a list of available FC ports and their current
status. Valid status values are Up, Down, Failed,
Reserved and Disabled.
FCPortList
FCPortRecover
Controls the behavior of Fibre Channel ports while the
unit is operating in port failover mode. The unit tries to
restore the pre-failover state after a failover condition.
FCPortRecover
FCTargets
Lists all target devices available on the Fibre Channel
port with the index specified by <fp>. If no port index is
specified, then all target devices on all Fibre ports is
displayed. A port-unique index is assigned to each target
which is used with the fp to specify a Fibre Channel target
for a subsequent Route CLI command.
FCTargets <fp>
FCWWName
Reports the Word Wide Name (WWN) of the FC interface.
Each FC port has an individual and unique WWN. The
least significant 3 bytes of the WWN are used as the
Ethernet MAC address. The lower nibble of the highest
byte designates the port number.
get FCWWN [fp | all]
FirmwareRestart
Resets and reinitializes the unit firmware. Use the forced
option to override any CLI reservations held by other
sessions.
FirmwareRestart <forced>