Instruction manual

3.0 Monitor storage, configurations ....................................................17
Health and Status Monitor page
Configuration Display page
Phone home: E-mail messages
Identify drive issues
Preliminary steps
Initialize and verify drives
Scan drive surfaces: read only drive test
Measure drive performance and health
Identify a drive attached to the FastStream
4.0 Modify storage ................................................................................23
Initialize and verify drives
Preliminary steps
RAID group processes
Add drives to a RAID group
Change RAID configuration: RAID migration
Modify RAID group mapping
Modify RAID group partitions
Rebuild RAID groups
FastStream process: add or remove Hot Spares
Update RAID configuration data
5.0 Update firmware, configuration data ............................................27
Update firmware
Preliminary steps
Use FTP over Ethernet
Use the RS-232 serial link
Update RAID configuration data
6.0 Interface options .............................................................................29
Use the ExpressNAV interface
Use the serial port
Use Telnet
Appendix A Designing RAID groups ....................................................i
JBOD (Just a Bunch of Disks)
RAID Level 0
RAID Level 1
DVRAID (Digital Video RAID)
RAID Level 10
RAID Level 5
Appendix B CLI provides an ASCII-based interface ...........................iii
CLI error messages
CLI summary
CLI command explanations
Appendix C Standards and compliances ............................................xvii
Appendix D Warranty, contact information .........................................xix
Manufacturer limited warranty
Contact ATTO Technology, Inc.