User's Manual

Federal Communications Commission Interference Statement

1.1 Liability for illegal acts

Anyone who uses this product for illegal purposes shall be liable and he or she shall be held responsible for all

and any consequences.

1.2 FCC licensing information

λ Federal Communications Commission Interference statement

NOTE: Change or modification not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures.

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio, TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two Conditions:

① This device may not cause harmful interference, and

② This device must accept any interference received, including interference that may cause undesired

operation.

NOTE: To comply with FCC RF exposure limits for general population/uncontrolled exposure, the antenna(s)

used for this transmitter must not be collocated or operating in conjunction with any other antenna or

transmitter.

exposure statements

NOTE: This module does not have RF shielding and needs to be tested inside a host device and submit for

C2PC filing whenever the host changed.

This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 20 centimeters between the

radiator and your body or nearby persons.

CFR 47 FCC PART 15 SUBPART C (Part 15.247) has been investigated. It is applicable to the modular

transmitter.

The devices must be installed and used in strict accordance with the manufacturer's instructions as described

in the user documentation that comes with the product.

We will retain control over the final installation of the modular such that compliance of the end product is

assured. In such cases, an operating condition on the limit modular approval for the module must be only