User Manual

Mounting Type
There are two ways of installation
Hook and Loop Mounting
The hook and loop tape included with your detector might be the best mounting
method for some dashboards.
Follow these instructions to use the hook and loop tape to mount the unit on the
dashboard.
1. Use a damp cloth to thoroughly clean the dashboard.
2. Peel off the paper backing of the tape and apply the tape to the bottom of
the detector
3. Remove the paper backing from the other side of the tape and press the
detector onto the dashboard.
Windshield Mounting
The supplied windshield bracket and suc tion cups l et y ou q uickly m ount the
detector on your vehicle’s windshield.
Follow these steps to use mounting bracket kit.
1. Install the suction cups onto the bracket by fitting them into their holes.
2. Attach the bracket to windshield.
3. Attach the detector to the bracket.
4. Bend bracket for correct detection angle.
5. Plug power cord DC12V into detector.
6. Plug power cord into cigarette lighter.
Cautions: Some new models of cars have a plastic safety coating which is applied
to the windshield. The suction cups may leave permanent marks on the wind
shield once they are re moved. Check vehicle owner’s manual to s ee if your car
has the plastic safety coating.
Connecting the Power
The CCT278 detector is designed to op erate on most DC 12V neg ative ground
vehicle ele ctrical sy stems. The power cord provided with the detector has a
cigarette lighter socket plug at one end and a small connector at the other.
1. Insert the small connector into the jack on the side of the detector.
2. Insert the other end into the cigarette lighter socket of your vehicle.
If the detector does not operate when you turn it on, remove the adapter from the
cigarette lighter socket and carefully check the socket for debris. Also, check the
fuse in the adapter and your vehicle's fuse box.
Replacing the Fuse
If the detecto r stops operating, the fuse in the cigarette lighter plug m ight be
blown. If it has blown, follow these steps to replace it:
1. To replace the fuse, unscrew the top of the plug.
2. Remove the fuse and check the fuse to see if it has blown. If it has, replace it.
OPERATION
1) Power On & Volume Control
Rotate the Power and Volume control wheel clockwise to turn the Power on/off.
This wheel can adjust volume up/down also by moving back and forth.
2) Memory
It will auto matically remember your last settings when the unit is turned off or
removed from the power. All features selected are retained in the memory except
for MUTE. Each time when power turns on, MUTE OFF will be set.
3) Display Brightness Control (Dim mode)
Dim mode r educes the il lumination of the display. Press the DIM button
repeatedly to tog gle between four leve ls of bri ghtness modes: Bright - Dim -
Dimmer – Dark